Siglent SDL1020X-E
A programmable load with every interface built in, for labs that automate power-supply and battery tests.
Amazon $574$574
150 V / 30 A200 W1
3.5/5
A 300 W programmable load with fine low-range resolution, for battery and supply testing past 200 W.
- 150 V / 40 AOutput
- 300 WPower
- Electronic loadType
- USB, RS232, LANPC control
Check price at Amazon$525
Price checked November 9, 2026. As an Amazon Associate we earn from qualifying purchases.
Pros
- 300 W, more than the Rigol and Siglent loads
- Very fine 0.1 mV and 0.1 mA steps on the low ranges
- USB, RS232 and LAN built in
- Remote sense
Cons
- No published warranty
- SCPI support is not documented
How it scores
The rating comes from 6 measured or published factors, each scored 0-100 against fixed reference points for its type. How we rank explains each one.
Specifications
| Model number | KEL2010 |
|---|---|
| Output | |
| Type | Electronic load |
| Channels | 1 |
| Channel ratings | 150 V/40 A, 300 W |
| Max voltage | 150 V |
| Max current | 40 A |
| Rated power | 300 W |
| Dynamic mode | 10 kHz |
| Load modes | CC, CV, CR, CP |
| Precision | |
| Setting resolution | 0.1 mV / 0.1 mA |
| Readback resolution | 0.1 mV / 0.1 mA |
| Remote sense | Yes |
| Control | |
| PC interfaces | USB, RS232, LAN |
| Stored setups | 100 |
| Over-voltage protection | Yes |
| Over-current protection | Yes |
Alternatives in this type
Rigol DL3021
A well-supported programmable load for testing power supplies and batteries in an electronics lab.
Amazon $549$549
150 V / 40 A200 W1
OWON OEL1530
A low-cost 300 W programmable load for battery capacity and power-supply testing on a hobby bench.
Amazon $215.99$215.99
150 V / 30 A300 W1
Compare
Compare the Korad KEL2010 with any other bench power supply →
More from Korad: every Korad product ranked.